Sound overwhelming? Then just start off focusing on Disston saws. The Disston saws were manufactured by the millions and are the easiest to find, and most are of exceptional quality, especially the below common models. Remember to buy pre 1940’s era vintage hand saws. Here are some ebay searches for wood saws. To ensure that you don’t over-pay, when you’re on ebay click “sold” to see what they’re selling before and to see which saws are desirable. It’s fun research:
When you are making a cut with the grain of the wood, use a ripsaw. In comparison with a cross cut saw, the teeth on a ripsaw are angled to the left and they are not beveled. The teeth bend left and right in an alternating pattern, which allows each tooth to act like a chisel that chips away small pieces of wood as you saw along the wood grain. Also, the rip saw's blade cuts on the push stroke, not on the push and pull stroke, like you would with a cross cutting hand saw.
With a pencil and a protractor, divide the larger disc into 30-degree wedges to create 12 center lines for the bottle indents. Center and trace the smaller disc on top of the larger disc. Next, with a drill press, drill 3/8-in.-deep holes on the 12 center lines with the 1-7/8-in. Forstner bit, spacing them between the disc’s outer edge and the traced circle. Next, divide the smaller disc into 60-degree wedges and drill six more 3/8-in.-deep holes with the Forstner bit.
Working on one side at a time, glue and nail the side to the back. Apply glue and drive three 1-5/8-in. nails into each shelf, attach the other side and nail those shelves into place to secure them. Clamps are helpful to hold the unit together while you’re driving nails. Center the top piece, leaving a 2-in. overhang on both sides, and glue and nail it into place. Paint or stain the unit and then drill pilot holes into the top face of each side of the unit and screw in the hooks to hold your ironing board. Mount the shelf on drywall using screw-in wall anchors.

Hand saws are mostly used for rough cutting a board to an approximate size. Rip hand saws, in particular, rip along the length of the grain (“ripping”). Look for a rip hand saw between 4-7 ppi (“points per inch”, or “teeth per inch”).  The ppi will usually be marked on the blade (can you see the number 5 on the above saw blade?). A 4 ppi rip hand saw will remove more wood, but may be more difficult to cut.

I am sharing here a link to the detailed tutorial written by Pete at diypete.com, who shares the step by step process for making a wonderful barrel coffee table from scratch. He also tells you what items you’ll need for this project and where to find them. For example, you can buy an old whiskey barrel online or from a local whiskey store for a few bucks, if you haven’t already got one.
With two varieties, red and white, oak is known to be easy to work with and relatively strong. However, furniture makers often opt for white oak over red oak for its attractive figure and moisture-resistance.[12] Depending on the kind needed, oak can probably be found at a local home center or a lumberyard for a bit pricier than other hardwoods.[12][13]
Don’t be afraid to ask if there are internship or apprenticeship opportunities. Even if you’re declined, people will know you’re looking, and if you continue to hang out in their circles and demonstrate that you’d be a model employee, someone will take notice. There’s no shortage of woodworkers, but there is a severe shortage of enthusiastic and phenomenal woodworkers.

All content on this blog is the property of Just the Woods, LLC. You are welcome to share my content (to include one photo only) as long as you provide a link back the original post. DO NOT copy entire posts, or crop, edit, or remove watermarks from photos without written permission from me first. Sharing a post from Just the Woods in a capacity where YOU will be compensated is not permitted. Thank you!
×